Using and Printing Ink Jet Decal Paper:

1. Using your computer, design and create your own custom decal

2.  Set your printer’s resolution to “Highest” or “Best” and choose “Photo” or “Gloss” for your paper option (you will be printing on the “glossy” side of the decal paper).

3.  After printing your decal, use Krylon’s® Acrylic Crystal Clear High Gloss Spray (don’t worry, we sell that too!), and apply an even shine on the sheet.  Allow 45 – 60 minutes drying time. 

4. Carefully cut and remove your decal using a pair of scissors.  Immerse the decal in a wide bowl of water for 30 - 60 seconds and remove once you see that the film detaches from the backing material.

5.  Your decal is now ready to be applied.  Please make sure all surfaces are clean before applying the decal. Carefully place and position the decal on the object.  Gently remove the backing paper and hold in position for approximately 30 seconds while the decal sets.  Add water to the surface as needed, patting dry the decal.  You may seal the decal with a gloss spray finish.

Using and Printing Laser Decal Paper:

1.              Using your computer, design and create your own custom decal

2.            Set your printer’s resolution to “Highest” or “Best” and choose “Photo” or “Gloss” for your paper option (you will be printing on the “glossy” side of the decal paper).

3.              Carefully cut and remove your decal using a pair of scissors.  Immerse the decal in a wide bowl of water for 30 - 60 seconds and remove once you see that the film detaches from the backing material.

4.              Your decal is now ready to be applied.  Please make sure all surfaces are clean before applying the decal. Carefully place and position the decal on the object.  Gently remove the backing paper and hold in position for approximately 30 seconds while the decal sets.  Add water to the surface as needed, patting dry the decal.  You may seal the decal with a gloss spray finish.

Using and Printing Temporary Tattoo Paper

1.    Using your computer, design and create your own custom tattoo.

2.    Set your printers resolution to “Normal” and choose “Plain Paper” as your paper option. (NOTE: Please allow the printed tattoo paper to dry thoroughly for 3 – 4 minutes prior to handling)

3.    Always feed one sheet at a time when printing.

4.    Remove the first side of the Adhesive Sheet and carefully apply it to the printed tattoo sheet.  Be sure to remove all air bubbles.

5.    Using a pair of scissors, carefully cut out each tattoo design.  (Tip: When cutting, try to keep as close to the edge of the tattoo design as possible)

6.    Your tattoo will work best if applied to skin that is clean, dry and free of body hair. 

7.    Carefully remove the adhesive backing and apply the tattoo to skin, pressing firmly for approximately 20 seconds.

8.    Using a damp sponge, wet the tattoo for 45 – 60 seconds until the paper is completely wet. 

9.    Remove the backing to reveal the tattoo.

NOTE:

Tattoo paper must be stored in a cool dry place.  We recommend you store the paper in its original plastic bag and always on a flat surface.